Stranding machines when used there are many accidents occur, a lot of people in the use of industrial machines often neglects some of the attention to detail and lead, so we must see a lot of attention proposed, such as commonly used in industry to be bundles of copper machines, bundle wire machine, twisted copper machine, stranding machine, extruder, extrusion machine stranding machines are also widely used in industrial manufacturing, and that the following should be noted with you to explain matters:
　　Safety devices are complete, functioning components are flexible and reliable, it is loose. Close the protective cover, check the machine if someone nearby and other insecurity, after the first bell rang boot, not allowed to use the normal start jogging in place while longer so that equipment operation. Always check and tighten cable gland chassis ground screw, etc., to prevent loosening. On-line-for-line after line planes to check whether the top tight top, lock prison. Equipment operation, shall not exceed the operating site, allowed someone to equipment in hazardous areas prescribed stay or move around. When equipment operation, to be observed actinomycetes inventory line, the need to observe the head or tail twister, generally not observed in the middle of twisted body, to prevent accidents. Equipment operation, are not allowed to shift Guadang, are not allowed to wipe the device and the cleaning. Equipment operation, equipment operation must continue to observe the situation, abnormal, should immediately stop treatment. Does not rule out equipment failure can not drive. When using chain hoist, allowed hanging crooked oblique pull, to hang or overload, hanging wire belts should be inspected regularly and, if damaged should be discontinued immediately replaced. When stranding stranding machine to have kink, should prevent extrusion die bad seat. Keep work area clean and smooth. If the waste line twister below and debris, before driving back to clear. Spools neatly prescribed area. Empty plate promptly shipped out channel. Note that the source of fire was to prevent fires. Once a piece of equipment overheated smoke, immediately shut down, and immediately reports of the personnel.